BS-1000 Double screw ribbon blender mixer dry powder mixing machine

Double screw ribbon dry powder mixing machine Application:

suitable for mixing and drying of plastic powder particles such as PVC, TRP, TPE, PP, PE (double heating: heat conduction oil is used as the heating medium, the heat is uniform, and it is convenient to control. The heat transfer oil in the mailbox is heated by an electric heating plate. Use this temperature to stir-fry and dry the materials in the barrel during the mixing process to achieve the purpose of mixing and drying).

Features of ribbon mixer:

The bottom discharge method of the ribbon mixer: manual butterfly valve or pneumatic butterfly valve is adopted for powder material, high fineness material and semi-fluid material. Manual butterfly valve is economical and applicable. Pneumatic butterfly valve has good sealing performance for semi-fluid, but the cost is higher than manual butterfly valve. .

The heating method of the spiral ribbon mixer: the jacket can be configured when heating or cooling is required. There are two heating methods: electric heating and steam heating. Electric heating is convenient, but the heating speed is fast and the energy consumption is high; steam heating requires boilers and pipes, etc., which requires a large investment and low energy consumption. The cooling process can directly inject cooling water into the jacket. The jacket has a large heat exchange area and a fast cooling rate.

Use and maintenance of horizontal ribbon mixer machine:
A1: When the Double screw ribbon dry powder mixing machine is running, no hard foreign objects larger than 5mm should enter the machine, otherwise it should be shut down to remove it. If abnormal noises such as metal collision or friction are found during operation, stop the machine and check and eliminate it in time.
A2: For solid-liquid mixing, it should be operated first, and then sprayed. After spraying, continue to run and mix for 3 to 5 minutes.
A3: The mixing time of a material is generally about 5-8 minutes. The mixing time of special materials needs to be determined by the user through experiments.
A4: The particle size of the mixed material is 20-1400 mesh; the amount of spray liquid can be determined according to the adsorption performance of the material and the user’s production process requirements.
A5: The lubricating oil of the reducer and bearings should be replaced regularly during use. The lubrication of the reducer shall be carried out according to the requirements of the reducer manual. Lithium complex grease for spindle bearings.
A6: The shaft end seal adopts packing seal. The sealing material is generally oil-impregnated asbestos. If there is a small amount of leakage during use, the compression bolts of the box cover should be tightened.

Technical of ribbon mixer: